The STORM DRAIN DEFENDER traps pollutants, reducing and controlling the entrance of contaminants into our water systems.
The STORM DRAIN DEFENDER is a simple sheet of geotextile fabric supported by a wire frame. The entire unit is under the grate, no excess fabric extends above the grate, creating a safer environment for pedestrians. No trimming required.
The Storm Drain Defender is an inexpensive, easy to use Best Management Practice (BMP), a vital part of any Storm Water Pollution Prevention Plan.
The first step to comply with the stringent EPA standards.
Approved by WSDOT and ODOT Quality Products List.
Specifications:
Size: Rectangular —Adjusts to fit Drains; smallest 16”X20”; largest 28”X36. ”The single fabric sheet is 4’x5’. The depth varies, depending on the size of the drain and how deep the fabric hangs down.
Material: 8 oz Polypropylene, non-woven geotextile fabric
Net Bag Pillow, made from polypropylene and absorbs hydrocarbons.
Flow Rate: Maximum overflow rate varies depending on the level of debris and sediment that has accumulated in the fabric. Proper maintenance is mandatory to maintain maximum water flow.
The STORM DRAIN DEFENDER units have overflow outlets to allow excessive water during heavy rain showers to bypass the system, reducing the chance of flooding or ponding.
Removes: Oil, Grease, Sediment, Litter, Debris.
Disposal: Disposal is dependent on nature of pollutants being collected.
Disposal should be in accordance with local, state and federal regulations.
Weight: Empty = STORM DRAIN DEFENDER W/OIL PILLOW units are approx. 5 lbs.
Full = Weight of empty unit plus weight of sediment and water trapped in unit. Dry sediment could weigh 30-50 pounds.
Fully loaded, wet units can weigh approximately 85-135 pounds.
Freight quotes are estimates only and do not include fuel surcharges that change daily. Actual rate may vary.
